Some g3c handguns have feed ramp issues that prevent them from properly lifting up and loading hollow point. Common issue on the g3 series. Cheaper, bulk ammo often lacks the consistent.
Taurus G3c does not load hollow points, even after polishing the ramp
What should i do if my taurus g3c isn’t feeding hollow points?
These problems ranged from the magazine not being properly seated to dealing with.
I have feed issued with hollow point ammo. Make sure you shoot it a lot with fmj and. Why do some taurus g3c handguns have trouble feeding hollow points? I have tried flat nose fmjs.
I asked lakeline if one of their g3c extended barrels would solve the problem. I’ve read a lot and seen a lot of comments pretty much saying every gun is different and handles ammo differently. When the mag is full and the cartridge is under max pressure from the mag spring, the nose of the bullet does not ride up the feed ramp. I just purchased a used g3c at my local sportsman's warehouse.
It takes a lot of rounds down range to break it in.
Greetings, i own a g3c and i’ve read that because of the steepness of the feed ramp some hollow point ammo will hang up and not feed smoothly. Having encountered various challenges with my taurus g3c over time, one issue that sometimes arises involves feeding hollow point bullets. I have a taurus g3c. It's jamming right at the point where the feed ramp meets the barrel and i can tell it's because either the.
If it is having trouble after a few hundred fmj, you might look at something like hornady critical duty or critical defense where they have the silicone insert in the hollow point. The g3c doesn't feed hollow points very well. Taurus g3c ftf fixed and tested!! Its pretty common and not just g3c's and.
As i haven’t run any hollow.
I have the jhp feeding issue, but my g3c will cycle round nose fmjs just fine. They need to be a shorter length, like 1.080. It appears that when the bullet moves from the magazine to the barrel, the bullet gets pushed hard into the. The bullets are to long, factory ammo is ususlly 1.125.
If you're loading hollow points, scrub the barrel and slide clean with brake cleaner or whatever solvent you use, and spray everything with some silicone dry lube. Has trouble feeding hollows sometimes. The feed ramp of my barrel. If your taurus g3c isn’t feeding hollow points properly, there are a few troubleshooting tips you can try.
Well, i spent this afternoon correcting the problem that i thought was my failure to feed problem with full taurus 12+ and promag 14+.
They seem to feed ok if i only load 5 or. I've read nearly every thread on this board about this failure to feed/feed ramp issue. The open bullet point catches on the feed ramp.
