Then mill out the interior of the spline to slightly smaller than your sway bar. I’m fine with removing everything including. After removal of the original parts, you may need to add some downward force on the overland custom design sway bar link to have the bolt from the lower sway bar link fit into.
5th Gen 4Runner Rear Sway Bar Links YouTube
We sought out some that would hopefully.
Restore your suspension, ride quality, handling, and off road capability after lifting your toyota by installing these custom made sway bar links!
For my stock '21 trd or i'm considering this: You may very well find the need to add some compression. Here you can see the front right tire stuffed to full bump and the right rear droop (not full). With sway bars, there would be induced roll due to restricted wheel travel, but without the.
Vs toyota only one side is flexed with a hydraulic ram. *a sway bar relocation is recommended where. Our 4runner has over 200k miles and the sway bar end links show it which we discovered after another modification we performed. Removing the sway bar should soften things up quite a bit and allow each wheel to travel independently of the other.
To remove it and add a traditional sway bar you will have to remove the full kdss system and weld in mounts for a traditional bar.
Obviously i don't have kdss on mine and i definitely need to be in touch. If you look at wrangler or bronco sway bar disconnects they truly split the sway bar and let it flex / rotate more freely. Unless yours is a dedicated offroader that will take a trailer to the trail,. The worst case is cut the rubicon sway bar ends remove it from the housing.
